Charging piles for electric vehicles can improve the conversion rate of new energy

The electric vehicle charging pile, bottom plate and rotating sleeve, which can improve the conversion rate of new energy, are fixedly connected with the middle part of the left side of the bottom plate through the fixing plate; The controller is fixedly connected with the middle part. At the top of the work board area. The electric vehicle charging pile that can improve the conversion rate of new energy can effectively improve the conversion rate of new energy by passing through the center of the left side of the bottom plate through the fixed plate and connecting with the rotating sleeve. The output end of the solar panel is connected to the input end of the inverter. The output end of the inverter is electrically connected to the input end of the battery, and the output end of the battery is electrically connected to the input end of the charging end, so that the electric vehicle charging pile can obtain more energy from the solar energy, so that it can be used in people. When used, more power can be obtained, which solves the problem of electric vehicle charging pile that the existing new energy conversion rate cannot be effectively improved. The conversion rate of new energy.

The control panel fixed on the surface of the electric vehicle charging pile body, the display light is fixed on the surface of the electric vehicle charging pile body under the control panel, and the rain cover is fixed on the upper end of the electric vehicle charging pile body, and several sinks are arranged on both sides of the rain cover. The upper end of one side of the loading pile body is fixedly connected with the heat dissipation window. The middle of the main body on both sides of the electric vehicle charging pile is fixed connected with the storage rack. Wired interface, the equipment is fixed at the bottom of the mobile equipment, easy to move, while avoiding the trouble caused by short line, higher practicability, has higher promotion and promotion value. Adopt. The device uses a jack, pin and copper wire. The combination of these blocks converts the current into direct current, improves the charging efficiency of electric vehicle charging pile, saves time, has high safety and reliability, and is easy to use for a long time.

Anti-theft damage of electric vehicle charging pile, through the bracket installed on the protection plate above the electric vehicle charging pile body, used to connect the charging end of the charging car, used to support the support rod of the electric vehicle charging pile body, therefore, the anti-theft base includes the upper cover plate, through the screw fixed to connect the upper cover plate under the bottom plate, as well as fastening bolts for fixing the anti-theft base, And the anti-theft base is hollow inside; Electric car charging posts are equipped with alarm lights. The lower substrate has plate A and plate B above the two sides of the elastic component, and plate C is fixedly connected to the elastic component, and plate C can be connected to plate A and plate B. Metal part A and metal part B are connected to the power supply of the alarm light by wire. The alarm structure is simple, the cost is reduced, the anti-theft performance is high, the cooling effect is good.